Hi all!  I've acquired a solar panel kit and now I would like to use only the 12V output to feed 2 devices (miniPC 12V 2A ) and a USB camera ( 12V ...  ) Does the output Solar Power...

i have bought two rigid 170 watt solar panels an Epever tracer bn séries 40amp mppt controller and mt 50 display to connect to an eco worthy 100ah battery on a steel boat. I would like to s...

I'm measuring 25.5 Volts on the multimeter out of the batteries into the inverter and the inverter is NOT powering on?

got a question, installed a 4800 watt off grid system for my a-frame house, install the inverter and batteries and am getting a fault code 5, which is battery overcurrent hardware in the manual, re...

I have begun installing an Eco-Worthy hybrid 400W Turbine with 10 Solar Panels and have wired everything to the Contoller properly and to the 4 Battery bank and to the 3500W Invertor, BUT, the inve...

IS THERE ANY EASIER INSTRUCTION ON TO SET THE CONTROLLER? VERY CONFUSING. ANY HELP BE GREAT. THANK YOU

WHAT SIZE CABLE DO I NEED TO USE WHEN I AM USING 8 100 WATT 5.57 AMP ECO-WORTHY PANELS AT LEAST 75 FEET FROM SOLAR GENERATOR.  WOULD 8AWG BE GOOD?

hi all, looking to power our off grid office with batteries and a 24volt inverter and 6 400w panels.   my question is this, currently we have 4 AGM batteries wired in series and parallel giv...

Hello Joshua, I would say the short answer to your question is yes, there will continue to be a small drain on the batteries as long as the inverter power is on.  I dont know how much of a dr...

Four panels connected in series will give you about 84VDC in full sunshine with no load.  If you connect these four panels in parallel to another set of four series connected panels, the overa...

I have the 1500W Off Grid Pure Sine Wave Inverter and have a quesiton concerning low-voltage shutdown. I am going to be out of town for most of the day and won't be back until after dark.  My...

I have a new 3.9kW 20 -195W panel system. My inverter reads PV output 84V in direct sun. I checked the control panel with a meter before & after fuses. 3 of 5 circuits ( 5 circuits , 4 panels e...

Hi,My name is Massimiliano and I bought an off-grid photovoltaic system with 4 solar panels and I wanted to ask you if you need to set the correct values in the charge controller when using an inve...

Hi, The inverter inside the kit should be a 12V version, which means it needs a 12V battery bank, so both panels and batteries should be wired in parallel. Or if you plan to replace the inverter ...

I have a 200w complete kit and another 200w addition, 4 batteries (12V/20Ah). So does all of this have to be connected as parallel? From Amazon, details:  [Easy Installation] : The back of...

Hi so how many batteries/panels would typical 3 bed house need.

It seems so. You mentioned you have 3 panels, but this one requires 48V circuit, according to title. So I guess it's not suitable for you. Maybe you consider paralleling your 3 panels and 3 batter...

Is this both inverter and charge controller? For three 200w solar panels and three 12V100AH Lithium Iron batteries, which one should I get? https://www.eco-worthy.com/collections/solar-inverters/p...

Hello, We've uploaded a video of setting guide to help you. You can just program the battery type as it shows. As for the LED indications, you could have a glance over below:  

Hi,   I owe your 10W 12V Monocrystalline Solar Panel Trickle Charger Kit and your 8AH LiFePO4 Battery is connected to this PWM Solar Charge Controller.   When I try to change battery...